Table of Contents
Advertisement
NLSet up and connect
If the device is tilted more than 40°,
residual water can run out of the
device and cause material damage.
Carefully tilt the device.
▶
Transport the device upright.
▶
installation site
Plinth
Floor with wooden
beams
kitchen
on a wall
14
To demand
The device with
locking lips
→ Page 30
to confirm.
Place the device
guess at a wa-
resistant
wooden plate (thick-
too minimal
30mm) which
screwed to the
floor.
The device al-
borrow under a
continuous work
place sheet,
that fixed with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
no snakes
between wall and
device clamping
man.
4.4 Removing transport locks
The device is secured for transport
with transport locks at the rear of the
device.
Remark:Keep the screws of the
transport locks and the sleeves for
later transport
→ Page 55 .
Pull the hoses out of the holders.
1.
Loosen and remove all bolts of the 4
2.
transport locks with a SW13 open-
end wrench
.
Advertisement
Table of Contents
