Table of Contents
Advertisement
Malfunction
Start several times
with centrifugation.
The water is not
visible in the drum
bar.
In the compartment
there is residual water.
Vibration and movement
of the appliance
during the spin
run.
Drum is spinning, er
no water flows into
the appliance.
strong foam
ming.
High spin speed
rental is not
reached.
Cause and Troubleshooting
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark:When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
The water is below visible range.
No error - no action required.
▶
▶ Do not fill the device with additional water during
operation.
Bet in compartment
→ "Cleaning the detergent drawer", Page
▶
40
The appliance is not leveled properly.
→ "Adjusting the device", Page 16
▶
Device feet are not fixed.
Secure the device feet.
▶
→ "Adjusting the device", Page 16
Transport protections have not been removed.
→ "Remove transport locks", page 14 .
▶
Load recognition is active.
No error, no action necessary.
▶
Remark:The load detection can take up to 2 minutes.
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
Reduce the amount of detergent for the next wash
▶
with an equal load.
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
is activated.
Select a suitable program for the type of fabric.
▶
Unbalance control system compensates for
imbalance through reduced spin speed.
Redistribute the laundry in the drum.
▶
TroubleshootingNL
is hidden.
49
Advertisement
Table of Contents
