Table of Contents
Advertisement
Mount the pump to suit the type of installation planned.
Very heavy lubricants may require an inductor plate.
See Dimensions on page 18 and Mounting Hole
Layout on page 19.
Install the air line accessories in the approximate order
shown in Fig. 2. Install a bleed-type master air valve
(B) within easy reach of the pump, upstream from the
air regulator (E). Install an air filter (C) to remove
harmful dirt and moisture from your compressed air
supply. For automatic air motor lubrication, install an
air line oiler (D) close to the pump air inlet. Install an
air regulator (E) to control pump speed.
The installations shown in Fig, 2 is only a guide for
selecting and installing system components and acces-
sories. Contact your Graco distributor for assistance in
designing a system to suit your particular needs.
If you supply your own accessories, be sure they are
adequately sized and pressure-rated to meet the
system requirements.
Typical Installation
A
C
Fig. 2
Installation
B
D
E
H
WARNING
A bleed-type master air valve (B) is required to
shut off and relieve air pressure that may be
trapped in the air motor. Trapped air could cause
the pump to cycle unexpectedly and cause serious
bodily injury, including amputation.
Be sure the air hose is properly sized to deliver an
adequate supply of air to the motor. See Technical
Data on page 19.
Connect a grounded dispensing hose (F) to the
3/8 npt(f) pump outlet. Install an appropriate gun or
dispensing valve (G) to the hose.
Ground the pump as explained in Grounding on
page 6.
Key
A Grounded air line
B Bleed-type master air valve
C Air filter
J
D Air line oiler
E Air regulator
F Grounded dispensing hose
G Dispensing valve
H Elevator assy. with inductors
J Ground wire
F
06309
G
308777H
7
Advertisement
Table of Contents
