Table of Contents
Advertisement
ENGLISH
Wear safety glasses or goggles when operating
this appliance.
N
Wear suitable ear protectors when operating this
appliance.
Always remove the battery from the appliance
before performing any cleaning or maintenance .
K
from the cutting area.
R
Do not expose the appliance to rain or high
humidity.
Directive 2000/14/EC guaranteed sound power.
Features
This appliance includes some or all of the following features.
1. On / Off Switch
2. Tube
3. Power command button (GWC1820PC Only).
Tube assembly
Note: Ensure the sweeper is switched off and the battery is
removed before attaching or removing the sweeper tube. The
tube must be assembled to the housing before use.
To attach the tube to the sweeper, line up the tube with the
u
sweeper housing as shown in Figure A.
Push the tube into the sweeper housing until the lock but-
u
ton (4) engages the lock hole (5) in the tube.
To install battery pack
Insert battery pack into tool until an audible click is heard
u
as shown in Figure B. Make sure battery pack is fully
seated and fully latched into position.
To remove battery pack
Depress the battery release button (6) in the back of the
u
battery pack and pull battery pack out of tool assembly as
shown in Figure C.
Operation
Warning!
the operation is dusty. Use of gloves, long pants and substan-
tial footwear is recommended. Keep long hair and loose cloth-
ing away from openings and moving parts. THIS SWEEPER
IS FOR HOUSEHOLD USE ONLY.
8
(Original instructions)
Hold the sweeper with one hand as shown in Figure D and
u
sweep from side to side with the nozzle several inches
above the ground. Slowly advance keeping the accumu-
lated pile of debris in front of you.
Switching on and off
Warning!
switching on.
Warning! Do not point unit discharge at self or bystanders.
To switch the sweeper on, slide the on/off switch forward
u
as shown in Figure E1 and E2.
To switch the sweeper off, slide the on/off switch back as
u
shown in Figure F1 and F2.
POWERCOMMAND feature
The POWERCOMMAND feature (3) is located on the
GWC1820PC tool handle as shown in Figure G. It allows you
to optimise the tools performance and boost the power as
needed.
Switch the blower on.
u
To activate the "Boost" mode, press and hold the
u
POWERCOMMAND button down.
To deactivate the "Boost" mode, release the
u
POWERCOMMAND button.
Operate in "Normal" mode for most sweeping needs.
u
(Longer runtime will be achieved.)
Activate "Boost" mode as needed to clear heavy or wet
u
debris.
Troubleshooting
Problem
Possible cause
Unit will not start.
Battery not installed
properly.
Battery not charged.
Battery will not charge.
Battery not inserted into
charger.
Charger not plugged in.
Surrounding air
temperature too hot or
too cold.
Possible solution
Check battery
installation.
Check battery
charging requirements.
Insert battery into
charger until green
LED appears.
Plug charger into a
working outlet. Refer
to "Important Charging
Notes" for more details.
Check current at
receptacle by plugging
in a lamp or other
appliance.
Check to see if
receptacle is
connected to a light
switch which turns
power off when you
turn out the lights.
Move charger and
tool to a surrounding
air temperature of
above 40 degree F
(4.5°C) or below 105
degree F (+40.5°C).
Advertisement
Table of Contents
