Bestway 43135E Owner's Manual

Model: #43126E/#43127E/#43135E
OWNER'S MANUAL

WARNING

• ATTENTION! NO PROTECTION AGAINST
DROWNING!
• SWIMMERS ONLY!
• Fully inflate all air chambers.
• This is not a life-saving device. Do not leave children
unattended while device is in use. Competent adult
supervision should always be provided.
• Keep away from flames and fires.
• Before every use, carefully inspect all product
components to ensure everything is in good condition
and tightly secured. Please stop and make repairs if
you find any damage.
• Be careful when placing product on the ground. Sharp
and rough objects such as rocks, cement, shells,
glass, etc. may puncture the product.
• Don't leave the product exposed to sun for long
periods of time. Otherwise, the product material is
likely to stretch andor change shape. This can cause
irreparable damage.
• Never leave in or near the water when not in use.
• Never use in stormy weather, or in rough conditions.
Seek shelter when lightning is present, DO NOT stay
on the product.
• Distribute persons or loads evenly. Uneven
distribution of persons or loads may result in tipping
and drowning.
• Use in calm shallow waters near the shoreline.
• Never allow diving to or from this product.
• Do not use for navigational purposes such as a boat.
This is not a boat.
• Do not tow product with a boat.
• Know and follow local water safety rules and
regulations.

SAVE THESE INSTRUCTIONS

Note: Do not over inflate. Do not use an air
compressor or compressed air.
Note: Never stand on or rest objectson the product
during inflation.
Note: Always check product for leaks before use.

ASSEMBLY

1. Take the island and accessories out with care.
Spread the island out.
2. Open the 3-interconnecting valves and inflate (the air
pump is not included). Close the valves after inflation
and press them into the air chambers.
3. Thread the rope through the grommets around the
outside of the island one by one. (Only for 43126E)
4. Connect the climb-up cushion to the island using the
ropes and knot the ropes to make the climb-up
cushion secure. (Only for 43127E)
5. Put the cooler bag inside its holder in the island.
(Only for 43126E)
6. Fill the anchor bag with rocks or sand to weigh it
down. Hang the anchor bag to make the island more
stable.

DISASSEMBLY

1. Remove all accessories from the island.
2. Pull out the stoppers of the 3-interconnecting valves
to deflate.

REPAIR

1. If the product is damaged, use the provided repair
patch.
2. Clean the area to be repaired.
3. Carefully peel the patch and remove it from the
backing.
4. Press patch over the area to be repaired.
5. Wait 30 minutes before inflation.

CLEANING AND STORING

1. After deflation, use a damp cloth to gently clean all
surfaces.
Note: Never use solvents or other chemicals that
may damage the product.
2. Store in a cool, dry place, out of reach of children.
3. Check the product for damage at the beginning of
each season and at regular intervals when in use.
Ref Description
A Island
B Anchor bag
C Rope
D Cooler bag
E Repair patch
F Climb-up cushion
A
B
D E
INFLATION
43135E
43126E 43127E
1 1
1 1
2 3
2 -
1 1
- 1
C
F
DEFLATION
303021206588
1
1
1
-
1
-