Replacing The Dvd Rom Drive; Replacing The Front Port Panel - Bosch DIP-7280-00N Installation Manual

40 en | Maintenance
9.7

Replacing the DVD ROM drive

The unit includes a DVD-ROM which is pre-installed.
To replace the DVD-ROM drive:
1.
2.
3.
4.
5.
6.
7.
9.8

Replacing the front port panel

If you must install a new or replace a damaged front port panel, observe the following
instructions.
2021.03 | V2 | DOC
1 DVD-ROM
Turn off the unit and if necessary, remove the unit from the rack.
Remove the chassis cover.
Unplug the drives power and data cables from the motherboard and/or backplane.
Locate the locking tab at the rear (on the left when viewed from front) of the DVD-ROM
drive. Push the tab toward the drive and push the drive unit out the front of the chassis.
Insert the new drive unit in the slot until the tab locks in place.
Reconnect the data and power cables.
Replace the chassis cover. replace the unit in the rack, if necessary, then turn on the
system.
1 DVD-ROM
1
2
1
2
Installation manual
DIVAR IP all-in-one 7000 2U
2
Front port panel
2
Front port panel
Bosch Security Systems B.V.