Bosch MUC4 RU Series Instruction Manual page 12

en Operation
Note: When the programme [ паста ] (pasta)
or [ фритюр ] ( deep frying) is selected, a
repeating audible signal is emitted and the
display and button G flash until the food
has been added and button G has been
pressed.
The preparation time counts down.
Steam that is formed when preparing the
meals exits the multi-cooker via the steam
outlet, thereby preventing the formation of
excess pressure. Depending on the model,
the steam outlet is fitted with a viewing
window.
Increasing or reducing the
temperature during preparation
If the current temperature was set too high
or too low during the preparation, this can
be increased (by +10°C max.) or decreased
(by -10°C max.) accordingly during the
cooking process.
To increase the temperature, press and
hold the C button. The current temperature
will be briefly shown on the display and will
then increase in 1°C increments until the
maximum value is reached (+10°C). Press
and hold the button until the temperature is
at the increased level desired.
To reduce the temperature, press and
hold button C. The current temperature will
be briefly shown on the display and will
initially increase in 1°C increments until the
maximum value is reached (+10°C). Once
the maximum value has been reached, the
display will jump back to the minimum value
(20°C lower). Press and hold the button
until the temperature is at the reduced level
desired.
To continue with the preparation
programme, press button G.
12
Note: If button G is not pressed, the
preparation programme will continue with
the temperature that was previously set.
When the preparation programme ends,
an audible signal sounds and the indicator
[ готово ] (finished) and button G light up.
The display flashes and shows "00:00".
5. Open the lid of the appliance and serve
the meal that has been prepared.
W Risk of scalding!
■ During preparation, large amounts of
steam may accumulate in the appliance.
Open the lid with care. Do not lean over
the lid of the appliance.
■ The pan and any inserts that are used
may be very hot. Always use pan tongs,
suitable handles or oven gloves.
Notes:
■ The preparation programme can be
stopped at any time using button H.
The appliance subsequently switches to
function selection mode.
■ If the preparation programme features
the keep warm function, this is switched
on automatically once the meal is ready
and keeps the meal warm for up to
10 hours at 40°C. [ готово ] (finished)
and [ подогрев ] (keep warm) light up.
A rectangle lights up in the display
(dotted lines). The keep warm function
can be ended using button H. The
appliance subsequently switches to
function selection mode.
If the selected preparation programme
consists of multiple preparation steps, an
audible signal sounds once the next step
needs to take place. In the control panel,
LEDs 1, 2, 3 or 4 are shown accordingly
and button G flashes. Perform the
following steps:
■ Open the lid of the appliance.
■ Add additional ingredients.
■ Close the lid of the appliance.
■ Start the next preparation step using
button G.