Table of Contents
Advertisement
7. Back Box Installation Stern
WHITESTAR
Locate the speaker connectors shown by the upper
red arrow in the picture. Remove the speaker
connector from the main CPU board by carefully
rocking the connector while pulling it out:
Plug supplied Pinnovators cable into the RJ45 jack on
the new Back Box Board Connector (non PINsub kits
only).
Insert the Back Box Board into the speaker
connectors on the sound card as shown above. Make
sure it's fully inserted and aligned properly.
ALIGNMENT is CRITICAL! You may damage
your sound board if the connector is not
properly aligned. Check it twice!
Note: The PINsub_WHITESTAR kit will not have
the black RJ45 connector loaded so you will not
have an RJ45 cable. The cable is part of the
Pinnovators headphone kit.
Insert the original Speaker cable on to the pins
of the Back Box Board.
Plug the 3.5mm cable end into the green female
connector on the Pinnovators Back Box Board.
6
Using the 12 foot 3.5mm to 3.5mm supplied
cable, poke the cable through the air vent
located above the main CPU board as shown
below.
Secure the cable into the nylon cable clamp to
protect the cable from being pulled out. The
nylon cable clamp does not have to be removed
to get the wire into it. The clamp can be slightly
stretched open.
Reassemble the Back Box.
Advertisement
Table of Contents
