Table of Contents
Advertisement
5. Back Box Installation Stern
SPIKE, Spike 2 systems
Locate the speaker connectors shown by in the
picture below. Remove the speaker connector from
the main CPU board by carefully rocking the
connector while pulling it out.
Plug the 3.5mm cable end into the green female
connector on the Pinnovators Back Box Board.
Insert the original Speaker cable on to the pins
of the Back Box Board.
Insert the Back Box Board into the speaker
connectors on the sound card as shown above. Make
sure it's fully inserted and aligned properly.
ALIGNMENT is CRITICAL! You may damage your
sound board if the connector is not properly aligned.
Check it twice!
4
Using the 12 foot 3.5mm to 3.5mm supplied
cable; drop the cable through the bottom of the
Back Box and into the main cabinet. Locate the
air vent located under the cabinet. Press up on
the screen just enough to allow the cable to exit
the system.
Secure the cable into the nylon cable clamp to
protect the cable from being pulled out. The
nylon cable clamp does not have to be removed
to get the wire into it. The clamp can be slightly
stretched open.
Reassemble the Back Box.
Advertisement
Table of Contents
