PINsub Installation Contents Manual Warnings and Agreements ......2 Preparation ..........2 Version 1.2 August 06, 2015 What’s included in the Kits ......3 Version 1.3 February 14, 2021 Requirements: ........... 3 This manual covers the following product kits: Back Box Installation Stern SPIKE, Spike 2 systems ..............
Pinnovators requires our kit be installed by an experienced Pinball service technician with basic electrical skills. As with any electrical piece of...
3. What’s included in the Kits Interface Cable and adapter come with all PINsub kits but is an optional accessory PinPAC 1 DCS Kit PINsub_DCS kit with headphone kits. One Velcro tie is included to hold the cable to the leg of the machine.
Back Box and into the main cabinet. Locate the Plug the 3.5mm cable end into the green female air vent located under the cabinet. Press up on connector on the Pinnovators Back Box Board. the screen just enough to allow the cable to exit the system.
Reassemble the Back Box. Note: The SAMsub kit will not have the black RJ45 connector loaded so you will not have an RJ45 cable. The cable is part of the Pinnovators headphone kit. Insert the original Speaker cable on to the pins...
Remove the speaker connector from the main CPU board by carefully rocking the connector while pulling it out: Plug supplied Pinnovators cable into the RJ45 jack on the new Back Box Board Connector (non PINsub kits only).
CPU board by carefully the cable to exit. rocking the connector while pulling it out: Plug supplied Pinnovators cable into the RJ45 jack on Secure the cable into the nylon cable clamp to the new Back Box Board Connector (non PINsub kits protect the cable from being pulled out.
Remove the speaker connector from the main CPU board by carefully rocking the connector while pulling it out: Plug supplied Pinnovators cable into the RJ45 jack on the new Back Box Board Connector (non PINsub kits only).
Page 9
Remove the speaker connector from the main CPU board by carefully rocking the connector while pulling it out: Plug supplied Pinnovators cable into the RJ45 jack on the new Back Box Board Connector (non PINsub kits only).
Connecting a Subwoofer Final Checkout Pinnovators provides a 12 foot cable to give you the Power up your subwoofer! flexibility of placing your subwoofer close by to your Power up your pinball system! pinball machine. The end of the cable has a 3.5mm Start a game! male plug on the end.