Table Of Contents - HWM COMLog 2 IS Quick Start Manual

TABLE OF CONTENTS

1 Prepare ............................................................................................................................... 3
2 Choose Logger Model ....................................................................................................... 4
3 Installation ......................................................................................................................... 5
4 Activate Logger / Wireless Communications .................................................................. 6
5 Checking and adjusting logger configuration. ................................................................ 6
6 Set Meter Reading of Flow Channel(s) ........................................................................... 11
7 Add any additional Combos ........................................................................................... 13
8 Call settings and tests ..................................................................................................... 13
9 Complete installation ...................................................................................................... 14
Note(s):
1. Loggers will be set to call in with meter reading data and other messages to a
server. This could be one of the HWM central servers or to your company's own
server (with HWM logger communication software installed).
2. Your logger may be pre-configured with a security setting requiring the use of
the HWM DataGate or FCS OmniColl central servers; these are referred to as
"secure loggers" and notes 5, 6 and 7 apply (see below).
Without this security setting, the loggers are referred to as "insecure loggers" and
notes 5, 6 and 7 do not apply (insecure loggers can be used without DataGate).
Alternatively, notes 5, 6 and 7 can be optionally applied (insecure loggers can be
optionally used with DataGate).
3. IDT will allow use without the app first logging in to the DataGate server (see link
at the app login page) but will only work with insecure loggers.
4. For additional information, refer to main product manual,
MAN-157-0002 "User Guide: COMLog2-IS / ISLog - Installation and Setup".
5. Loggers must be pre-registered on DataGate.
6. User must be pre-registered on DataGate.
Contact your System Administrator (or your HWM Sales representative) to obtain
your server URL, username, and password information, etc.
7. Assumes DMAs are pre-registered on DataGate.
2