Install A Bgw320-505 Indoor Ont - Nokia ONT BGW320-505 Product Manual

Install or replace a BGW320-505 indoor ONT

Install a BGW320-505 indoor ONT

WARNING
Equipment Damage
This equipment is ESD sensitive. Proper ESD protections should be used when removing the fiber
access cover of the indoor ONT.
Do not directly connect the 10G PON ONT to the 10G PON OLT.
CAUTION
Service Disruption
Keep indoor ONTs out of direct sunlight. Prolonged exposure to direct sunlight can damage the unit.
Note: Observe the local and national laws and regulations that may be applicable to this
installation.
Observe the following:
• The indoor ONT should be installed in accordance with the applicable requirements of the
NEC or CEC. Local authorities and practices take precedent when there is conflict between
the local standard and the NEC or CEC.
• The indoor ONT may require the presence of a fiber termination, which must be installed
by qualified service personnel.
• Indoor ONTs must be installed with cables that are suitably rated and listed for indoor use.
• See the detailed specifications in the
temperature ranges for these ONTs.
4.4 Install a BGW320-505 indoor ONT
1
There is a risk of overheating if the BGW320 is not properly ventilated. The unit should not be
placed in an enclosed cabinet or location without proper ventilation.
Make sure the temperature requirement described in Section
specifications" (p. 30)
Place the indoor ONT unit on a flat surface, such as a desk or shelf.
Note: The BGW320-505 ONT cannot be stacked with another ONT or with other
equipment. The ONT mounting requirements are:
• Place the unit in a vertical upright position with the feet and grill facing down and the
• Allow a minimum 100 mm clearance above the top cover
36
WARNING
Equipment Damage
are adhered to.
flat top facing up
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-47753-AAAA-TCZZA
Chapter 3, "BGW320-505 unit data sheet"
3.7 "BGW320-505 detailed
BGW320-505
for the
June 2022
Issue 3