Nokia ONT BGW320-505 Product Manual page 38

Install or replace a BGW320-505 indoor ONT
Install a BGW320-505 indoor ONT
5
Fiber cables transmit invisible laser light. To avoid eye damage or blindness, never look directly
into fibers, connectors, or adapters.
Be careful to maintain a bend radius of no less than 1.5 in. (3.8 cm) when connecting the fiber
optic cable. Too small of a bend radius in the cable can result in damage to the optic fiber.
Connect the fiber optic cable with an SFP adapter into the SFP+ connector; see
"BGW320-505 ONT connections" (p. 37)
Note: Fiber cable preparation varies depending on the type and size of the inside or
outside plant fiber cable being spliced to the SC/APC fiber optic pigtail cable.
6
Install the power supply according to manufacturer specifications.
Note: Observe the following:
• Units must be powered by a Listed or CE approved and marked limited power source
7
Power up the ONT unit by inserting the power cable.
8
If applicable, use the WPS button to connect additional Wi-Fi devices to the ONT.
9
Verify the ONT LEDs; see
LEDs.
10
Test the services by connecting to your device (cell phone, laptop, or computer) and access a
well known web-site.
11
If necessary, reset the ONT.
a. Locate the Reset button on a BGW320-505 indoor ONT as shown in
38
DANGER
Hazard
WARNING
Equipment Damage
power supply with a minimum output rate of 12VDC, 4A.
3.6 "BGW320-505 service LED" (p. 29)
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-47753-AAAA-TCZZA
for the location of the SFP connector.
BGW320-505
Figure 4-1,
for a description of the
Figure 4-1, "BGW320-
June 2022
Issue 3