Table of Contents
Advertisement
Power On
1.
To turn the unit ON press and re-
lease the power button.
OK
2.
Check the battery level icon
to ensure the batteries just
installed contain the proper
charge level. If so, you are ok to
proceed with camera use.
NOTE: LCD cycle through camera in-
formation. Time > PIR picture number
> Flextime number > Remaining pic-
tures > Temperature
page 5
POWER
RESET
Test Mode
1.
LCD Ready Mode: The camera will
automatically enter Ready Mode if a
button is not pressed for greater than
30 seconds. The status lights will il-
luminate for a total of 2 minutes.
2.
PIR LED Status Light: During the
first 2 minutes of Ready Mode, the
red light will illuminate when a PIR
event is triggered. The red light will
blink for 2-3 seconds when photo
is taken during this first 2 min-
utes. After 2 minutes all indicator
lights will turn off until a button is
pressed.
Advertisement
Table of Contents
