Hochdruckreiniger / Pressure Washer /
Nettoyeur haute pression PHDP 180 C2
Hochdruckreiniger
Originalbetriebsanleitung
Nettoyeur haute pression
Traduction des instructions d'origine
Myjka ciśnieniowa
Tłumaczenie oryginalnej instrukcji obsługi
Vysokotlakový čistič
Preklad originálneho návodu na obsluhu
Hidrolimpiadora
Traducción del manual de instrucciones original
Magasnyomású tisztító
Az originál használati utasítás fordítása
Visokotlačni čistač
Prijevod originalnih uputa za uporabu
Водоструйка
Превод на оригиналното ръководство за експлоатация
IAN 498560_2204
Pressure Washer
Translation of the original instructions
Hogedrukreiniger
Vertaling van de originele gebruiksaanwijzing
Vysokotlaký čistič
Překlad originálního provozního návodu
Højtryksrenser
Oversættelse af den originale driftsvejledning
Idropulitrice ad alta pressione
Traduzione delle istruzioni d'uso originali
Visokotlačni čistilec
Prevod originalnega navodila za uporabo
Aparat de curățat cu presiune ridicată
Traducerea instrucţiunilor de utilizare originale
Πλυστικό μηχάνημα υψηλής πίεσης
Μετάφραση των αυθεντικών οδηγιών λειτουργίας
Need help?
Do you have a question about the PHDP 180 C2 and is the answer not in the manual?
Questions and answers
Using the washer and it suddenly stopped working,electricity and water ok
The Parkside PHDP 180 C2 washer could stop working despite having electricity and water due to the following reasons:
1. Air Locks in the Pressure Washer – Air bubbles in the system can prevent proper pressure buildup. To fix this, bleed the washer by turning it on and pressing the switch lever.
2. Pressure Loss in the Line – A drop in water pressure can occur if the water supply is insufficient. Check the water supply to ensure proper flow.
3. Leaky Water System – Improperly installed or leaking connections can cause pressure issues. Turn off the device, disconnect it, and reconnect it correctly.
4. Leaky Water Connection – A faulty quick connector or sealing ring on the garden hose might be leaking. Replace the connector and sealing ring if necessary.
5. Dirty or Clogged 3-in-1 Nozzle – A dirty or clogged nozzle can cause pressure fluctuations. Rinse it with water and clean the bore hole with a needle if needed.
Checking and addressing these issues should help restore the washer's functionality.
This answer is automatically generated