Omron Promi-SD 205-OA User Manual page 16

Promi-SD 205-OA User Manual – 2. Configurations
LED Indicators
Indicator
Mode0
Mode1
Mode2
Mode3
Connected
RS232-Tx and RS232-Rx LED are blinking accordingly when data is transmitted. For small data transmission, it may be
hard to recognize the quick blinking.
Serial Ports
The applicable settings for serial ports are as follows.
Serial Port Settings
Baud rate
Data bit
Parity
Stop bit
Hardware Flow Control
The values in box are the factory defaults.
  Data Bit
Promi -SD supports only 8 data bit. In the case of 7 data bit, please contact the technical support.
Reset to Factory Defaults
To turn back all the configurations to its factory settings, press the reset button depicted in Fig. 1-3. Press the reset
button with a narrow pointed tool like paper clip longer than 1 second. Reset works only when power is on.
Dip Switch (Promi-SD205 OA)
This feature is only on Promi-SD205 OA. With the combination of 4 slot dip switches, baud rate can be set simply without
host computer.
Power LED
Green
┏━━━━━━━
Green
┏━━━━━━━
Green
┏━━━━━━━
Green
┏━━━━━━━
Green
┏━━━━━━━
Values
1200, 2400, 4800, 9600 , 19200, 38400, 57600, 115200, 230400
8
No parity , Even parity, Odd parity
1 , 2
No use
Reset Button
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
Standby LED
Red
┏━━━━━━━
Dip Switch
Pairing Button
Connect LED
Green (every 1 sec) ┏┓
Green (every 3 sec) ┏┰┓
Green (every 3 sec) ┏┰┓
Green
┏━━━━━━━
14