EINHELL SKA 2501 EQ C+H Operating Instructions Manual page 9

Anleitung SKA 2501 EQ C+H_GB:_
Preparation for use of the remote control
- The radio signal has a range of approx. 6 m.
- When the ON/OFF button is pressed, the indoor device will
emit an audio signal once or twice to indicate that the device
has received the signal.
- If you do not hear a signal, press again.
- Handle the remote control with care and, in order to avoid
malfunctions, never drop it or leave it in a damp location.
Attach the remote control to the wall in such a way that the
receiver on the indoor device can receive the remote control
signal effectively.
Changing the batteries!
- If the signal on the remote control becomes weak or the
indicator on the remote control becomes difficult to read,
replace the batteries immediately.
- It is important that the + and – terminals on the batteries are
correctly positioned in the remote control.
- Both batteries should always be new and of the same make.
Remote control fails to work (emergency operation)
If the remote control fails to work (empty batteries or malfunction),
use the emergency switch.
- Press the emergency switch several times and the device switches
off.
Note:
For the first 30 minutes the temperature adjustment does not yet
function. The device runs in continuous mode and at the fastest fan
speed.
- The device is on: The device switches off if the emergency switch
is pressed.
- The device is in setup or clock off mode: The device switches to
standby if the emergency switch is pressed.
07.12.2006 14:09 Uhr Seite 9
Emergency
switch
9