Accessing The Programming Mode - Viking E-60-SS Product Manual

D. Accessing the Programming Mode
The E-60 can be programmed from any Touch Tone phone using a telephone line, Viking model C-
200, C-250 or C-2000B Entry Phone Controller, analog PABX/KSU station or a Viking model DLE-
200B Line Simulator.
Step 1 Move DIP switch 1 to ON (Sets unit to answer incoming calls, see Section C).
Move DIP switch 3 to ON (incoming calls automatically enter the programming mode,
Step 2
see Section C).
Step 3 From a touch tone phone call the line attached to the E-60.
When the E-60 answers, 2 beeps will indicate that you have accessed the
Step 4
programming mode.
When finished programming, enter "0000" to exit programming and move DIP switch
Step 5
3 to the OFF position.
E. Quick Programming Features
Call length time out (1-9 minutes), 10 = disabled (factory set to 11111 =
5 minutes)
Silence time out for disconnect (10-90 seconds), 10 = disabled (factory
set to 1111 = 40 secs)
Talk/listen delay (VOX switching speed) 0.1 - 0.9 seconds (factory set
to 111 = 0.3 secs)
Forced hang-up command (used to exit programming and hang up the
E-60)
F. Programming Beeps
If a valid "Feature" is entered, a single beep will be heard and you will have 20 seconds to enter a
"Time" value. If an invalid "Feature" (five or more zeros) or forced hang-up command (four zeros)
is entered, 3 beeps will be heard and the E-60 will hang up. If a valid "Time" is entered 2 beeps will
be heard and you will have 20 seconds to enter your next "Feature". If an invalid "Talk/Listen Delay
Time" is entered (10 or more ones), 3 beeps will be heard and you will have 20 seconds to enter
your next "Feature".
6
Select Wait for Enter Time
feature beep(s)
0 beep
00 beep
000 beep
See Table A
0000 3 beeps
Page 7
Wait for
2
Value
beeps
beep
111...
beep
beep
111...
beep
beep
111...
beep