LG VR95 Ser Series Service Manual page 49

All manuals and user guides at all-guides.com
Check CLIFF sensor assembly
direction and wire direction
(blue is right side)
Assemble both side CLIFF to have the
connector to be at the bottom, and the
central CLIFF to be at the left side
Check PSD sensor
assembly direction
First insert the connector, and assemble
both sides PSD for the connector to be at
the top
Be careful for IR wire not to
be inserted
During the assembly of WINDOW LED in
BASE, be careful not to have the rear IR
wire pressed
Do not have wire passing
over the guide
If wire is over the guide, it may be pressed
by the main board during the assembly, and
it may cause short circuit.
Assemble PCB after wire
connection
Assemble after inserting all connectors
before the assembly of front IR and
ultrasonic.
Insert TP sensor all
the way
After pushing in wire into rubber, assemble
TP sensor fully in the guide, and insert
connector,
-49-
Cover rubber after
assembly of wire