Table of Contents
Advertisement
Chapter 1 Introduction
1.3 Specification
EM-660 Series
!" Processor
!" Chipset
!" System Memory / RAM
!" VGA/LCD
!" Ethernet
!" BIOS
!" RTC
!" Flash Memory Disk
!" IDE Drive Interface
!" Floppy Interface
!" Serial Port
!" Parallel Port
!" Keyboard/Mouse
!" Universal Serial Bus
!" IR Interface
!" Expansion Bus
!" Digital I/O
!" Watchdog Timer
!" Health Monitoring
!" Power Connector
!" Operating Temperature
!" Storage Temperature
!" Humidity
!" Dimensions
!" Net Weight
!" EMI/EMS
1.4 Unpack your EM-660 Series
Before you begin to install your card, please make sure that you received the following materials as listed
below:
Standard Packing:
!" E M-660 x 1 pc
!" D river Utility CD-ROM x 1 pc
!" U ser's Manual x 1 pc
!" C omport Cable x 1 pc
!" F loppy Cable x 1 pc
!" F loppy Cable x 1 pc
!" A TA Cable x 1 pc
!" I DE Cable x 1 pc
!" N ut & Spacer x 4 sets
2
: On board VIA C3 EBGA Ultra Low Power Processor, up to 133MHz,
Intergrated 192 KB internal L1/L2
: VIA VT8606 North Bridge & VT82C686B South Bridge, FSB 133MHz
:
One SODIMM socket supports up to 256MB SDRAM
:
SDRAM PC 133/PC100
: VIA Twister Chip with Integrated S3 Savage 4 2D/3D Video Accelerator,
Support up to 36-bit TTL LCD and 2 channel (2!18 bit) LVDS Reserved
Design Option: LCD Brightness Control via GPIO
Support 8/16/32 MB Display Memory (Shared)
One DB-15 VGA connector and one 2x8x2.54 mm box-header
: One RJ-45 connector, Realtek RTL8100B, 10/100 Base-T interface
: 256KB Award license BIOS
: Internal RTC with Li battery
: Type I/II CFC Socket supports up to 512 MB flash memory disk or IBM Micro
Drive up to 1GB
: PIO mode 4 and Bus Master. Also supports Multi-word DMA and Ultra DMA
33/66/100, one 2x20x2.54 mm PCI IDE port and one 2!22!2.00mm,
support up to four IDE devices.
: One 1x26x1.0 mm FDD port (support one floppy device)
: Four COM ports with ESD protect, COM1 RS-232/422/485 DB-9 connector,
COM2 RS-232 DB-9 connector, COM3 RS-232 DB-9 connector, and COM4
RS-232 2x5x2.54mm Box-header
: One multi-mode parallel port (SPP/EPP/ECP) DB-25 connector
: One 6-pin mini-DIM PS/2 keyboard/mouse connector and one 6-pin 1x6x2.54
mm internal keyboard/mouse header (KBDAT, MSDAT, KMGND, KC-FUS,
KBCLK, MSCLK)
: Support USB 1.1; 2 x external Connector, (Reserved design 2 x internal
pin-header)
: Supports one IrDA header
: Built-in one PCI & PC/104 expansion slot
: Digital-in*4 and digital-out*4
: Software 16 level time-out intervals
: Integrated in 686B
: On-board power connector, with one ATX/AT co-design power connector
optional and one HDD 4T connector
: 0°C ~ 60°C
: -20°C ~ 70°C
: 5% ~ 95% RH, non-condensing
: 219x159 mm +/- 0.5mm
: 350 g (0.77 pounds)
: Meet CE and FCC class A regulation
Embedded Single Board Computer
Drivers & Utilities
This User's Manual
D-SUB 9P To 2!5P with Key 230mm EDI
26P Flat 200mm (up contact)
26P Flat 200mm (down contact)
ATA100 40P IDE Impendence with Key
40P!2 to 44P P20 with Key EDI
15mm hex-spacer
User's Manual
Advertisement
Table of Contents
