Lanner electronics EM-660 Series User Manual page 50

Chapter 3 BIOS Setup
Power Management:
Min. Power Saving
Max. Power Saving
User Defined
Video Off Option: This option is for choosing the setting in which the monitor will turn off. The default
setting is "Suspend".
Always On
Suspend
All Modes
Video Off Method: This determines the manner in which the monitor is blanked. The default setting is
"V/H SYNC+Blank".
V/H SYNC+Blank
Blank Screen
DPMS
Suspend Mode: Power saving by suspends mode setting.
HDD Power Down: Options are from "1 Min". to "15 Min". and "Disable". The IDE hard drive will spin
down if it is not accessed within a specified length of time.
LPT & COM: Print Port and COM Port turn on/off.
Power On by LAN/Ring: When Enabled, an input signal on the serial LAN/Ring Indicator (RI) line (in
other words, an incoming call on the modem) awakens the system from a soft off state.
Power On by RTC Alarm: Power-on interval by RTC setting.
PwrOn After AC Power Loss: This option specifies the Power ON/OFF Status after AC power loss.
46
Minimum power management.
Suspend Mode=1hr., and HDD Power Down=15min.
Maximum power management. –Only available for SL CPU's. Doze
Mode=1min., Standby Mode=1min., Suspend Mode=1min., and HDD Power
Down=1min.
Allow you to set each mode individually. When not disabled, each of the
ranges is from 1 min. to 1 hr. except for HDD Power Down, which ranges
from 1 min. to 15 min. and disabled.
Always turn on.
During Suspend mode, the monitor will be turned off.
During All Modes mode, the monitor will be turned off.
This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blank to the video buffer.
This option only writes blanks to the video buffer.
Initial display power management signaling.
Doze Mode=1hr. Standby Mode =1hr.,
User's Manual