Lanner electronics MB-X63 Series User Manual page 34

3.6 I
NTEGRATED
When you select the "INTEGRATED PERIPHERIALS" on the main program, the screen display will
appears as:
Integrated Peripherals Setup Screen
OnChip IDE Channel 0
OnChip IDE Channel 1
IDE Prefetch Mode
Primary Master
Primary Slave
Secondary Master PIO
Secondary Slave
Primary Master
Primary Slave
Secondary Master UDMA
Secondary Slave
Init Display First
IDE HDD Block Mode
Onboard FDD Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART 2 Mode
IR Function Duplex
X TX, RX inverting enable
X Onboard Parallel Port
Onboard Parallel Mode
ECP Mode Use DMA
X Parallel Port EPP Type
X Onboard Leqacy Audio
Sound Blaster
SB I/O Base Address
SB IRQ Select
SB DMA Select
MPU-401
MPU-401 I/O Address
á â àß Move
OnChip IDE Channel 0 : The chipset contains a PCI IDE interface with support for two IDE channels.
Select Enabled to activate the primary IDE interface. Select Disabled to deactivate this interface.
The settings are "Enabled" and "Disabled".
OnChip IDE Channel 1 : The chipset contains a PCI IDE interface with support for two IDE channels.
Select Enabled to activate the secondary IDE interface. Select Disabled to deactivate this interface.
The settings are "Enabled" and "Disabled".
IDE Prefetch Mode : The onboard IDE drive interfaces supports IDE prefetching for faster drive
accesses. If you install a primary and/or secondary add-in IDE interface, set this field to Disabled if
the interface does not support prefetching. The settings are "Enabled" and "Disabled".
Primary / Secondary Master / Slave PIO : The four IDE PIO (Programmed Input/Output) fields
let you set a PIO mode (0-4) for each of the four IDE devices that the onboard IDE interface supports.
Modes 0 through 4 provide successively increased performance. In Auto mode, the system
automatically determines the best mode for each device. The settings are "Auto", "Mode 0", "Mode
1", "Mode 2", "Mode 3", "Mode 4".
P
ERIPHERALS
CMOS Setup Utility – Copyright © 1984-2001 Award Software
Integrated Peripherals
PIO
PIO
PIO
UDMA
UDMA
UDMA
Enter: Select +/-/PU/PD: Value
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Enabled
Enabled
Enabled
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
PCI Slot
Enabled
Enabled
3F8/IRQ4
2F8/IRQ3
Standard
Half
No, Yes
378 / IRQ7
Normal
3
EPP1.9
Enabled
Enabled
220H
IRQ 5
DMA 1
Disabled
330-333H
F10: Save Esc: Exit F1: General Help
30
Item Help
Menu Level