Table of Contents
Advertisement
DRIVERS SUPPORTARD BIOS SETUP
3.12 IDE HDD A
If your system has an IDE hard drive, you can use this utility to detect its parameters and
enter them into the Standard CMOS Setup automatically.
If the auto-detected parameters displayed do not match the ones that should used for
your hard drive, do not accept them. Press the <N> key to reject the values and enter
the correct ones manually on the Standard CMOS Setup screen.
Note : If you are setting up a new hard disk drive (nothing on it) that supports LBA mode,
more than one line will appear in the parameter box, choose the line that lists LBA
for an LBA drive.
Do not choose Large or Normal if the hard disk drive is already fully formatted when you
install it, choose the mode "HDD Low Level Format" to format it.
3.13 HDD L
OW
Select and highlight this option, then press the <Enter> key to enable you to perform the
low level format of hard disk drive.
3.14 S
& E
AVE
Select this option and press the <Enter> key to save the new setting information in the
CMOS memory and continue with the booting process.
3.15 E
W
XIT
ITHOUT
Select this option and press the <Enter > key to exit the Setup Utility without recording
any new values or changing old ones.
D
UTO
ETECTION
L
F
EVEL
ORMAT
S
XIT
ETUP
S
AVING
AP-370VF/F / 56
Advertisement
Table of Contents
