Lanner electronics AP-370VF Manual page 10

JUMPER SETTING AND CONNECTORS
I
NSTALLING THE
A DIMM module simply snaps into a socket on the system board. Pin1 of the DIMM
module must correspond with Pin1 of the socket.
Tab
Pin1
1. Pull the "tabs" which are at the ends of the socket to the side.
2. Position the DIMM above the socket with the "notches" in the module aligned with the
"keys" on the socket.
3. Seat the module vertically into the socket. Make sure it is completely seated. The
tabs will hold the DIMM in place.
DIMM M
ODULE
Notch
Key
AP-370VF/F / 6
:
Tab