Lanner electronics AP-370VF Manual page 11

JUMPER SETTINGS AND CONNECTORS
2.3 J S O
UMPER ETTING VERVIEW
In order to select the operation modes of your system, configure and set the jumpers on
your SBC to match the needs of your applications. To set a jumper, a black plastic cap
containing metal contacts is placed over the jumper pins as designated by the required
configuration as listed in this section. A jumper is said to be " on " or " 1-2 " when the
black cap has been placed on two of its pins, as show in the figure below:
A pair of needle-nose pliers is recommended when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local sales representative before you make any changes. In general, you simply need
a standard cable to make most connections.
AP-370VF/F/ 7