Table of Contents
Advertisement
Installation
Distance from the right side to the wiring inlet:
500002573
, 500002574
Evolve 50
500002608
Evolve 74
6. Drive four supplied mounting screws through the four mounting holes located on the inside surface of the
replace chassis, into wall studs. (Figure 5)
7. Complete the wiring according to instructions in the Electrical Installation section (pages 12–13).
8. Complete the installation using the instructions in the following sections: Mirrored Glass Installation (page 15),
Arranging Media (page 15), Front Glass Installation (page 16).
!
NOTE: Install the rebox ush with the surrounding wall/framing. The face of the rebox should not be
recessed. Any overhang from the surrounding framing can result in an error with the heater.
,
Evolve 60
13"
(330.25mm)
Figure 5
500002563
Evolve 100
Mounting Holes
20"
(508.4mm)
11
Advertisement
Table of Contents
