eltherm ELTC-14 Operation Manual
Temperature controller up to 400 c with connection possibility for 2 trace heaters
Hide thumbs
Also See for ELTC-14:
- Operating instructions manual (12 pages) ,
- Operating manual (9 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for eltherm ELTC-14
Summary of Contents for eltherm ELTC-14
- Page 1 OPERATION- MANUAL ELTC-14 Temperature controller up to 400°C with connection possibility for 2 trace heaters eltherm GmbH P.: +49 2736 4413-0 BU-094 F.: +49 2736 4413-50 Ernst-Heinkel-Strasse 6 -10 Revision 9 57299 Burbach, Germany info@eltherm.com www.eltherm.com...
- Page 2 PARAMETERS AND THEIR MEANING Notes on commissioning Declaration of Conformity HOUSING CONSTRUCTION DOWNLOADS For proper and safe use of the ELTC-14 temperature control- ler, please follow these instructions. Please keep these instructions for future reference (e.g. in the system documentation). RESERVATION Subject to technical changes.
- Page 3 (WEEE) and collection 1 Pcs. M12 O-ring points, please contact your local waste management com- 1 Pcs. Terminal cover pany or the manufacturer from whom you purchased the product. 2 Pcs. Redetachable rivets Contact us: +49 2736 4413-0 • info@eltherm.com www.eltherm.com...
- Page 4 FUNCTIONAL DESCRIPTION & TECHNICAL DATA FUNCTIONAL DESCRIPTION If the actual value (P01) falls below the setpoint (P10 minus hysteresis P11), relay K1 switches the heating on. The integrated alarm relay enables error messages via a changeover contact in case of over / under temperature, sensor interruption or sensor short circuit.
- Page 5 NOTE After switching on the controller, the display shows the current actual value. Contact us: +49 2736 4413-0 • info@eltherm.com www.eltherm.com...
- Page 6 OPERATION OPERATING PANEL LEDs in Display "1" = Control relay ON "4" = Alarm relay activated (=switched OFF) A flashing of the LEDs indicates a function delay. Keys " " = Increase values " " = Decrease values "P" = Programming key Protection against unauthorized operation After switching on, the type number ("C14") and software version of the device appear and after approx.
- Page 7 4 = Relay K2 (passive) drops in case of sensor error Load relay K1 energizes in case of sensor error 5 = K2 works as enable relay Load relay K1 energizes in case of sensor error Contact us: +49 2736 4413-0 • info@eltherm.com www.eltherm.com...
- Page 8 *dependent on the respective separate connection set DOWNLOADS You can find helpful downloads for this or other products under the following link: https://eltherm.com/downloads eltherm GmbH Headquarters Ernst-Heinkel-Straße 6 -10 57299 Burbach. Germany T.: +49 2736 4413-0 F.: +49 2736 4413-50 info@eltherm.com...
Need help?
Do you have a question about the ELTC-14 and is the answer not in the manual?
Questions and answers