Troubleshooting
Troubleshooting
Manual Test Mode
Manual Test Mode Commands
Table 3. Test Commands
Test Command
Press and hold # for 2 seconds Enter manual test mode
01#
07x#
08#
09#
10#
15x#
1590#
1591#
16#
19#
20#
36#
360#
361#
362#
37#
38#
39#
43x#
47x#
51#
36
Motorola A388c telephones are equipped with a manual test mode capability. This
allows service personnel to verify functionality and perform fault isolation by
entering keypad commands.
To enter the manual test command mode, a GSM / DCS test SIM must be used.
Press , to turn the phone OFF.
1.
2.
Remove the battery as described in the procedures.
3.
Remove the customer's SIM card from the phone as described in the
procedures.
4.
Insert the test SIM into the SIM slot.
5.
Replace the battery as described in the procedures.
Press , to turn the phone ON.
6.
Press and hold the # button for approximately 3 seconds until TEST displays on the
screen. The phone may now be issued test commands listed in Table 3.
Exit manual test mode
Mute RX audio path
Unmute RX audio path
Mute TX audio path
Unmute TX audio path
Generate tone
Vibrate Mode
Ringer Mode
Mute tone generator
Display software version number of Call Processor
Display software version number of Modem
Initiate acoustic loopback
Full Rate
Enhanced Full Rate
Half Rate
Stop test
Activate Mini SIM
Deactivate Mini SIM
Change audio path
Set audio volume
Enable sidetone
Test Function/Name
March 21, 2003
Product Family 0C81
6809462A54