After Use; Troubleshooting - Invacare Aquatec Pure Bidet Manual

Aquatec® Pure Bidet
Disinfection Instructions
Method: Follow the application notes for the used
disinfectant and wipe-disinfect all accessible surfaces.
Disinfectant: Ordinary household disinfectant.
Drying: Allow the product to air-dry.
6.3 Changing Batteries of Remote Control
The battery life cycle depends on the frequency of use.
CAUTION!
Risk of Remote Control Damage
– Only use batteries of type AA (LR6) 1.5 V.
– Insert batteries according to the +/- indicator
in the remote control.
– Do not use old and new batteries together.
1. Change used batteries into new ones when "BATTERY
SIGN" LED blinks on the remote control, see Assembling
the Remote Control, page 5 .

7 After Use

7.1 Transport and Storage
NOTICE!
Risk of Damage to the Product
– Store the product indoors.
– Store and transport the product in a dry
environment. For temperature and humidity
limits see chapter 9.3 Environmental Parameters,
page 11.
– Do not store the product near heat sources.
– Keep the product out of direct sunlight.
NOTICE!
– If not in use for a long time, drain the water
tank completely, see chapter 4.4 Disassembly,
page 6 .

8 Troubleshooting

8.1 Identifying and repairing faults
Fault
Unit does not operate at all
CLEANSING, BIDET, DRY, AUTO do not
operate
Remote control does not operate at all
Malfunction of the remote control
No water spray
Low water pressure
10
7.2 Reconditioning
This product is suitable for reuse. To recondition the product
for a new user, carry out the following actions:
•
•
For detailed information, see 6 Maintenance, page 9 .
Make sure that the user manual is handed over with the
product.
If any damage or malfunction is detected, do not reuse the
product.
7.3 Disposal
Be environmentally responsible and recycle this product
through your recycling facility at its end of life.
Disassemble the product and its components, so the different
materials can be separated and recycled individually.
The disposal and recycling of used products and packaging
must comply with the laws and regulations for waste handling
in each country. Contact your local waste management
company for information.
Possible cause(s)
Power is off
Power plug is not connected
There is a power failure
Seat is covered
Batteries in the remote control have
been exhausted
Batteries are empty or too weak
Remote control out of reach of the
device
The shut off valve is closed
There is water supply outage
The water pressure level is set to "LOW" Increase water pressure level,
The water strainer is clogged
Inspection
Cleaning and disinfection
WARNING!
Environmental Hazard
Device contains batteries.
This product may contain substances that could
be harmful to the environment if disposed of
in places (landfills) that are not appropriate
according to legislation.
– DO NOT dispose of batteries in normal
household waste.
– DO NOT throw batteries into a fire.
– Batteries MUST be taken to a proper disposal
site. The return is required by law and free of
charge.
– For information on the battery type see battery
label or chapter 9 Technical Data, page 11.
Remedy
Press any button to check except "HIGH",
"LOW", "FRONT" or "BACK" buttons of
the remote control.
Make sure that there is nothing on
the seat surface. (The device is only
activated when the user's skin touches
the seat sensor.)
Replace batteries with new ones,
→ 4.1 Installation / Assembly, page 4 .
Replace batteries with new ones,
→ 4.1 Installation / Assembly, page 4 .
Open shut off valve.
Restore water supply.
→ 5.4 Using the Shower Toilet, page 7 .
Clean water strainer, → Cleaning
Instructions, page 9 .
1590625-G