Bosch PAM 220 Original Instructions Manual page 27

English | 27
The measured value is displayed, regardless of whether the base leg and
fold-out leg are moved, until you press the Hold (9) button again.
Measuring with Leg Extension (see figures F–H)
The leg extension (2) makes it possible to measure angles when the contact
surface is shorter than the fold-out leg (1).
Attach the leg extension (2) (see "Attaching the Leg Extension
(see figure B)", page 25). Place the base leg (3) and the leg extension (2)
flat on the surfaces adjacent to the angle.
The measured value of the angle w between base leg and fold-out leg is in-
dicated in the display. The required angle v between base leg and leg exten-
sion is calculated as follows:
v = 180° – w
If you press the 180° button, the required angle v (supplementary angle)
will be calculated and displayed.
v
w
"Simple Mitre" Measurement
The "Simple mitre" measurement is used to calculate the cutting angle MTR
when two workpieces with the same mitre have to form any outer angle x°
smaller than 180° (e.g. for skirting boards, banister columns or picture
frames).
Bosch Power Tools 1 609 92A 7M7 | (11.05.2022)