Adjust Traction Drive Clutch - Gravely 926064 Operator's Manual

1. Attachment Clutch Cable
2. Cable Adjustment Barrel
3. Jam Nut
Figure 27
5. With the attachment clutch disengaged,
check that the attachment idler arm lightly
touches the frame. See Figure 28.
1
2
1. Attachment Idler Arm
2. Frame
Figure 28
6. Tighten jam nut on cable adjustment
barrel.
7. Reinstall belt cover and tighten hardware.
8. Reconnect spark plug wire.
1
3
Check Belt Finger Clearance
See Figure 29.
With the attachment clutch and traction clutch
engaged, the belt finger located opposite the
belt idler must be less than 3.2 mm (1/8")
from belts, but must not touch the belts.
To adjust belt finger:
1. Remove belt cover.
2
2. Loosen bolts and move belt finger to
correct position.
3. Tighten bolts and recheck belt finger
clearance.
4. Reinstall belt cover and tighten hardware.
ADJUST TRACTION DRIVE
CLUTCH
See Figure 30.
1. Stop engine, remove key and wait for all
moving parts to stop and for hot parts to
cool.
2. Disconnect spark plug wire.
3. Remove hardware securing belt cover to
unit and remove belt cover.
4. Loosen jam nut on traction cable
adjustment barrel, and then turn
adjustment barrel down to shorten cable
and remove cable slack.
EN - 19
3.2 mm (1/8")
Figure 29