Set Brush Angle; Move Unit Manually - Gravely 926064 Operator's Manual

2. Raise brush:
a. Remove lynch pins from caster shaft
tops.
b. Remove desired amount of height
adjuster clips from caster shaft tops
and install onto lower caster shaft
ends.
c. Turn height adjuster clips so they DO
NOT align with flat side of caster
shafts.
d. Reinstall lynch pins.
1
3
1. Lynch Pin
2. Caster Shaft
3. Height Adjuster Clip
Figure 13

SET BRUSH ANGLE

See Figure 14.
1. Squeeze brush lock trigger to unlock
brush position.
2. Move handlebars left or right until brush is
in desired position.
3. Release trigger to lock brush position.
2

MOVE UNIT MANUALLY

See Figure 15.
To disengage transmission and move unit
with the engine off, pull the bypass rod
outward.
Push the rod in to engage the transmission
for normal operation.
EN - 12
Figure 14
Figure 15