Maintenance Schedule; Service Parts; Check Dual Handle Interlock; Check Fasteners - Gravely 926064 Operator's Manual

MAINTENANCE SCHEDULE

Service Performed
Check Clutch Lever
Operation
Check Dual Handle
Interlock

Check Fasteners

Clean Recoil Guard Foam
Cover

Check Engine Oil

Check Clutch Cable
Adjustments *

Check Tire Pressure

Change Engine Oil **

General Lubrication
* After first use.
** Refer to engine manual for instructions.

SERVICE PARTS

See your Gravely dealer to purchase service
parts for your unit.
Description
Gravely Hi-Temp Grease
• 3 oz. cartridges (3)
• 14 oz. cartridge (1)
Fuel Stabilizer (4 oz.)
Spark Plug
Gravely 5W-30 Engine Oil
• 16 oz.
CHECK DUAL HANDLE
INTERLOCK
1. Stop engine.
2. Engage traction clutch and then the
attachment drive clutch.
3. Release the attachment clutch lever. The
attachment clutch should stay engaged
until the traction drive clutch lever is
released.
CHECK FASTENERS
Check for loose hardware.
•
•
•
•
•
•
•
• •
Part No.
00036800
00036700
04730400
04742500 (for
Canada Only)
21547200
00091000
EN - 16
CHECK CLUTCH CABLE
ADJUSTMENTS
Brush must stop within 5 seconds when
attachment clutch lever is released.
Wheels must stop quickly when traction drive
clutch lever is released.
If clutches do not engage or disengage
correctly, see Adjust Attachment Clutch on
page 18 or See Adjust Traction Drive Clutch
on page 19.
CHECK TIRE PRESSURE
Keep tires inflated to pressure listed on tire
sidewall.
WARNING: AVOID INJURY.
Explosive separation of tire and
rim parts is possible.
• DO NOT inflate tires above
the recommended pressure.
• DO NOT inflate tires with a
compressor; use a hand
pump.
• DO NOT stand in front of tire
assembly when inflating. Use
a clip-on chuck and extension
hose long enough to allow you
to stand to one side.
• DO NOT mount a tire without
proper equipment and
experience.
CHECK ENGINE OIL
NOTICE: Engine oil level must be maintained
at correct level or engine damage may occur.
Refer to engine manual.
CHANGE ENGINE OIL
Refer to engine manual.
CLEAN RECOIL GUARD FOAM
COVER
The recoil guard foam cover must be kept
clean and free of snow and debris.
If cover becomes clogged, remove and gently
vacuum or wash with warm water.
IMPORTANT: Cover MUST be installed when
using unit in winter conditions. The cover
prevents snow from entering the recoil guard
and freezing the recoil pawls. Cover is not
necessary for operation during non-winter
months.
IMPORTANT: If cover is clogged with snow,
remove it and allow foam to thaw or rinse with
warm water. Allow cover to dry before
reinstalling.