Daikin FMA50RVMA Operation Manual page 23

ADJUSTMENT
For programming TEMPERATURE, FAN SPEED
and AIRFLOW DIRECTION, follow the procedure
shown below.
TEMPERATURE SETTING
Press TEMPERATURE SETTING button
and programme the set temperature.
Each time this button is pressed, set
temperature rises 1°C.
Each time this button is pressed, set
temperature lowers 1°C.
• Temperature cannot be set in FAN
OPERATION and DRY OPERATION modes.
In case of AUTOMATIC OPERATION
• In AUTOMATIC OPERATION mode, the
relative temperature as compared to the
standard set temperature is displayed.
Remote controller display Set temperature [°C]
STD -3
STD -2
STD -1
STD
STD +1
STD +2
STD +3
NOTE
• The set temperature range of the remote
controller is 16°C to 32°C.
FAN SPEED CONTROL
Press FAN SPEED CONTROL button.
Fan speed can be selected.
• The micro computer may sometimes control
the fan speed in order to protect the unit.
• The fan speed may be changed automatically
depending on the indoor temperature.
The fan may be stopped, but this is normal.
• It may take some time until the airflow switch is
completed, but this is normal.
• Fan speeds supported depend on the model
that is connected.
• In " " (Auto), the fan speed is adjusted
according to the set temperature and the
temperature in the room.
However, in FAN OPERATION mode, fan
speed is fixed.
English
• The fan speed will not be displayed if the indoor
unit does not have fan speed control function.
The up/down airflow direction position switches
each time the up/down airflow direction button is
pressed.
Movement of the airflow direction blades
Under the operating conditions described below,
airflow direction is controlled automatically, so it
may differ from the airflow direction displayed on
the remote controller.
19
20
21
22
23
24
25
Operating
conditions
* HEATING OPERATION mode includes cases in
which operation is set to "
UP AND DOWN AIRFLOW
DIRECTION ADJUSTMENT
P0
P0 P1
Swing P0
P4
When the room
temperature is
higher than the
set temperature
(for HEATING
OPERATION)
When HEATING
OPERATION
starts and when
in DEFROST
OPERATION mode
(for HEATING
OPERATION)
During continuous
operation with
the air blowing
downward or
horizontally
P2
P3
The air is blown
horizontally so
that the airflow is
not directed at the
body.
The air is blown
horizontally so that
the cold airflow is
not directed at the
body.
The air conditioner
operates with a
different airflow
direction for a
certain period of
time to prevent
condensation build-
up on the airflow
direction blades.
".
8