OTHER DAMAGE TO THE EQUIPMENT. BE SURE ONLY for gas pipe for liquid pipe 16 pieces TO USE ACCESSORIES MADE BY DAIKIN WHICH ARE Other: installation and operation manual, fuse SPECIFICALLY DESIGNED FOR USE WITH THE EQUIPMENT AND HAVE THEM INSTALLED BY A Screws for fixing panels are attached to the air inlet panel.
For the following items, take special care during ELECTING INSTALLATION SITE construction and check after installation is finished (See figure 1 figure Tick Select an installation site where the following conditions are when fulfilled and that meets your customer's approval. checked Where optimum air distribution can be ensured.
For other installation than standard installation, contact your Daikin Installation with rear duct and duct service opening (See dealer for details. figure 6b) The fan speed for this indoor unit is preset to provide standard external static pressure. Installation with rear duct, no duct service opening (See figure 6c)
EFRIGERANT PIPING WORK RAIN PIPING WORK For refrigerant piping of outdoor unit, refer to the installation manual Rig the drain piping as shown in the figure and take measures supplied with the outdoor unit. against condensation. Improperly rigged piping could lead to leaks and eventually wet furniture and belongings.
LECTRIC WIRING WORK Caution for drain socket Do not remove the drain pipe plug. Water might leak out. General instructions The drain outlet is only used to discharge water if the drain pump is not used or before maintenance. Gently put in and All field supplied parts and materials and electric works must out the drain plug.
Setting of static pressure changeover connector IRING EXAMPLE AND HOW TO SET THE REMOTE CONTROLLER According to the systems static pressure requirement, reposition the adaptors of the PC board inside the switch box as shown in the figure. How to connect wiring FMDQ50+60 FMDQ71~125 From the outside of the unit...
Control by 2 Remote Controllers (Controlling 1 indoor PRECAUTIONS unit by 2 remote controllers) A single switch can be used to supply power to units on the same system. However, branch switches and branch circuit When using 2 remote controllers, one must be set to "MAIN" and the breakers must be selected carefully.
NSTALLATION OF THE DECORATION PANEL AINTENANCE Refer to the installation manual attached to the decoration panel. Caution After installing the decoration panel, ensure that there is no space Only a qualified service person is allowed to perform between the unit body and decoration panel. maintenance.
How to clean air outlet and outside panels Remove the air filters. Remove the air filters by pulling their cloth upward (rear suction) Clean with soft cloth. or backward (bottom suction). When it is difficult to remove stains, use water of neutral detergent.
Need help?
Do you have a question about the FMDQ50A7V3B and is the answer not in the manual?
Questions and answers