Advertisement
Safety Precaution
Package
Main Features
Overview
Charge the Battery
Start the
device
DVD Playback
Camera Function
Wi-Fi Connection
Bluetooth connection
Screen Cast Connection
Text Input
Battery Use
Trouble shooting
Reset Your Tablet to Factory Default
LIMITED PRODUCT WARRANTY
01
04
04
05
06
06
08
10
11
12
13
14
14
15
16
16
18
24
Advertisement
Need help?
Do you have a question about the ELITE PELTDV1029 and is the answer not in the manual?
Questions and answers
after a factory reset internet will not open
After a factory reset, the ProScan ELITE PELTDV1029 may not open the internet because the Wi-Fi connection needs to be reconfigured. The device requires reconnecting to a Wi-Fi network and entering the correct credentials. Additionally, if the reset erased network settings, the user must set up Wi-Fi again in the device settings.
This answer is automatically generated
Tried turning on proscan elite it lights up for a second I have charged it is there anything I can do to fix problem
If the ProScan ELITE PELTDV1029 lights up for a second but does not turn on, follow these steps:
1. Charge the Device – Connect the USB cable to the device and use the included power adapter to plug it into a power outlet.
2. Wait for Charging – Allow the device to charge for at least 5 minutes.
3. Check for Response – If the screen still does not light up, continue charging for a longer period.
4. Seek Assistance – If there is still no response after charging, contact after-sales service for help.
Use only the provided power adapter to avoid damage.
This answer is automatically generated
What button do I push to play dvd
To play a DVD on the ProScan ELITE PELTDV1029, press the "Open" button on the top of the unit to open it, load a disc, then close the unit. The disc will start loading, and you can choose to play.
This answer is automatically generated
I left my device on the charger for longer than 24 hours. Now it will not turn on.
Your ProScan ELITE PELTDV1029 may not turn on after being left on the charger for over 24 hours because overcharging can damage the battery. The manual advises not to leave the device on the charger for very long after it's fully charged, as this may cause battery failure. Additionally, if the device has not been used for a long time, it may show no charging indication when powered up. In that case, keep it connected to power and wait 5–10 minutes.
This answer is automatically generated
@Mr. Anderson
@Mr. Anderson , so what can I do to make it turn on after being overcharged?
I need a replacement power cord for the Proscan Elite PELTDV1029. I can order online if you tell me what to ask for. Thank you!
The ProScan Elite PELTDV1029 uses a USB power adapter and USB cable for charging. The manual specifies to use only the included power adapter. An incompatible adapter may cause damage. A replacement should match the original included power adapter.
This answer is automatically generated
Fastboot mode stays on. Can't start unit.
To resolve the Fastboot mode issue on the ProScan PELTDV1029, follow these steps:
1. Press and hold the power button until the device turns off.
2. Turn the device back on and see if it boots normally.
3. If the "Fastboot" or "Reboot system now" message still appears, a factory reset may be required.
4. Note: A factory reset does not fully erase the device. You will need the previously used PIN, Google account, password, or phone number to complete setup.
5. If the issue continues, the device may need professional repair or support.
Be aware that user data may still remain on the device after a reset.
This answer is automatically generated