Table of Contents
Advertisement
overhead storage - attachment
to back connector (cont'd)
4. Hang the overhead storage on
the installed wooden cleat.
Secure with, #8, 2-inch flat head
wood screws from the pre-drilled
holes inside back panel of the
overhead storage, through the
back connector, (Figure 3).
5. Cover the exposed screws with
the fastcaps provided.
NOTES:
> make sure no electrical wires are
on the way of the screws.
July 2023
FIGURE 3
STORAGE
CONNECTOR
WIDTH
WIDTH
30"
27.75"
36"
33.75"
42"
39.75"
48"
45.75"
54"
51.75"
60"
57.75"
66"
63.75"
72"
69.75"
It is the owner's responsibility to ensure that the wall type
and construction is of sufficient strength to carry the loads of
the overhead storage unit and its contents. Failure of the wall
to support all imposed loads may result in property damage
and/or personal injury. When in doubt, the use of other
methods of storage such as freestanding storage units,
hutches and bookcases is strongly recommended.
measuring
drill
tape
#8, 2-INCHES
FLAT HEAD
WOOD SCREWS
# OF
SCREWS
6
8
10
WARNING
!
torpedo level
stud finder
tools & hardware needed
#8;2" flat head
Philips bit
wood screw
metro 72
Advertisement
Table of Contents
