Section 1: Storage Instructions; Short Term Storage; Long Term Storage - Emerson Bettis 2000 Series Installation And Maintenance Manual

Installation and Maintenance Manual
E2K-401-0918 Rev. 1

Section 1: Storage Instructions

1.1

Short Term Storage

(Stored at job site less than one year from shipment)
1.
Figure 1
2.
3.
4.
5.
1.2

Long Term Storage

(Stored more than one year from shipment)
1.
Failure to store actuator properly will void warranty of electrical & electronic components.
Storage Instructions
Actuator should be stored in the recommended mounting position. The motor
should be horizontal and Electrical Enclosure either horizontal or vertical.
Actuator should be stored indoors free from job site dirt, mud, moisture and
temperature changes.
If indoor storage is not possible, the actuator must be stored off the ground, above
possible water or snow level. Remove MCP and store with other electrical and
electronic equipment in protected warehouse. If MCP is not removed,
Space Heater MUST be energized to protect Electrical and Electronic Controls.
Bettis supplies plugs in each conduit entry. Do not remove until electrical hook-up.
Cover units loosely with a plastic sheet. This serves as partial protection from rain.
Store indoors or MCP must be removed and stored in protected area. Follow
procedures of short term storage.
WARNING
Section 1: Storage Instructions
September 2018
1