World Tech Toys NANO HERCULES - 3.5 Channel IR Helicopter Manual

Also See for NANO HERCULES:

Manual (1 page)

Instruction manual (5 pages)

Table of Contents

Contents

1 REMOTE CONTROL TRANSMITTER
2 BATTERY INSTALLATION
3 PREFLIGHT CONDITIONS
4 HELICOPTER TAKEOFF
5 FLIGHT CONTROLS
6 ADJUSTMENTS
7 CHARGING
8 TROUBLESHOOTING
9 BATTERY CHARGING INDICATORS
10 Documents / Resources
- 10.1 References
- 10.2 Download manual

World Tech Toys NANO HERCULES - 3.5 Channel IR Helicopter Manual

REMOTE CONTROL TRANSMITTER

Power Indicator LED
Power Switch
Throttle Control Stick
Channel Selector
Rudder Control Stick
Trim Adjustment Knob
Infrared Emitter
Throttle Speed Regulator
LED Light Control

BATTERY INSTALLATION

Unscrew cover and install 6x AA Batteries as shown.
Please note polarity and orientation of batteries.

PREFLIGHT CONDITIONS

Be sure that Helicopter Battery is fully charged and Remote Control Batteries are fresh.
Helicopter will fly best in low wind conditions.
Fly Helicopter in a wide open area with no people, pets, and other objects in the way.
Do not fly in strong winds. This will make operation difficult and crash the Helicopter.

Parental Guidance is suggested for children operating Helicopter.
Multiple Helicopters operating simultaneously must be on different Frequency Bands.

HELICOPTER TAKEOFF

Place Helicopter on a flat surface. Turn on the Transmitter and the Helicopter
Check surroundings to be sure that it is clear of people, animals, and obstructions.
Slowly push the Throttle Stick up to increase blade speed for lift.
Adjust throttle input to maintain a steady hover.

FLIGHT CONTROLS

The Left and Right Sticks will move the helicopter as follows:
FLIGHT CONTROLS

ADJUSTMENTS

If the Helicopter is rotating on its own, slowly adjust the Trim Control Knob

Switch between High Speed & Low SpeedLight Modes

Switch LED Modes

CHARGING

Helicopter can be charged from: USB, Controller, or AC Charger
Move the Helicopter Power Switch to the OFF position
Connect Charging Adapter to Helicopter Charge Port.
Once charging is complete, disconnect Charging Plug from Helicopter.
Helicopter is ready for flight.

TROUBLESHOOTING

Problem	Cause	Solution
The Transmitter indicator LED does not work	Batteries installed with the wrong polarity.	Check the polarity of the batteries and install them Correctly.
The Transmitter indicator LED does not work	Batteries are drained.	Install new batteries.
No control of the helicopter	Helicopter is not IR receiving signal from transmitter.	Point Transmitter at Helicopter or operate in conditions with less sunlight.
	Windy Conditions.	Fly helicopter in calm conditions.
	Helicopter is not receiving signal from transmitter correctly.	Test the control functions of the helicopter in a hover by applying light throttle and testing left and right controls.
Helicopter is not flying high enough	Rotor speed is too slow.	Push Left Control Stick up for more rotor speed.
Helicopter is not flying high enough	Batteries are drained.	Fully charge helicopter before use.

ATTENTION

READ THESE INSTRUCTIONS BEFORE OPERATING THE HELICOPTER

Install only new batteries of the same type in your product.
Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten the life of the batteries or cause batteries to leak.
Do not mix old and new batteries.
Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries.
Do not dispose of batteries in fire.
Batteries should be recycled or disposed of as per state and local guidelines.

BATTERY CHARGING INDICATORS

RED light on USB charger will turn on when plugged in and is not charging the helicopter. Red light will turn off when the helicopter battery is charging.
When charging from the remote, the power/charge indicator LED light will turn yellow when charging. The light will turn RED when the helicopter is fully charged.

Website: www.worldtechtoys.com;
MADE IN CHINA
Email: customerserv@worldtechtoys.com
Phone: (877) 498-8697
Monday - Friday / 9:00AM - 5:00PM / Pacific Time
WWW.WORLDTECHTOYS.COM ;
SPECIFICATIONS, COLORS AND CONTENT MAY VARY FROM ILLUSTRATIONS