IMPORTANT SAFEGUARDS Before using the electrical appliance, the following basic precautions should always be followed including the following: 1. Read all instructions. 2. Before using check that the voltage of wall outlet corresponds to rated voltage marked on the rating plate.
26. If you cut off power during steam release, residual heat will make product continue to release steam for a length of time, the product will stop releasing steam immediately once you turn off steam knob. 27. When the product is working for the first time, press the coffee button. If the coffee outlet does not come out of the water, open the steam knob to exhaust and then close the knob.
BEFORE THE FIRST USE To ensure the first cup of coffee tastes excellent, you should rinse the coffee maker with warm water as follows: 1. Open water tank cover, fill water into water tank, water level should not exceed the “MAX” mark in water tank.
Page 5
MAKE ESPRESSO 1. Remove funnel by turning it clockwise. Add ground coffee into steel mesh with measuring spoon, a spoon of ground coffee powder can make about a cup of top-grade coffee, then press ground coffee powder tightly with the tamper. 2.
MAKE CAPPUCCINO/FROTHED MILK You get a cup of cappuccino when you top up a cup of espresso with frothed milk. Method: 1. Prepare espresso first with container big enough according to the part “MAKE ESPRESSO COFFEE”, make sure that the steam control knob is at the “o” position. 2.
FACTORY RESET After finish preheating, hold and press double cup coffee switch and steam switch for 3 seconds at the same time, and their corresponding indicators will blink for 3 times, then the factory reset is finished. CLEANING AND MAINTENANCE 1.
TROUBLE SHOOTING Symptom Cause Corrections The descaler is not recommended descaler type. It may corrode the metal parts in recommended The metal parts in the tank the tank. manufacturer. have rust. Water leaks from the bottom There is much water in the drip tray. Please clean the drip tray.
Need help?
Do you have a question about the R-98020 and is the answer not in the manual?
Questions and answers