Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ACTi Q970
Summary of Contents for ACTi Q970
- Page 1 Intercom Camera Hardware Manual Q970 2022/03/23...
-
Page 2: Table Of Contents
Connecting Serial Devices (Optional) ........... 13 Other Accessories How to Install / Remove the Memory Card ........14 How to Remove the Memory Card ..........14 Accessing the Camera Configure the IP Addresses ............15 Access the Camera ................. 19 www.acti.com... -
Page 3: Precautions
Every reasonable care has been taken during the writing of this manual. Please inform your local office if you find any inaccuracies or omissions. ACTi will not be held responsible for any typographical or technical errors and reserves the right to make changes to the product and manuals without prior notice. - Page 4 This product has been tested and found to comply with the limits for Class B Information Technology Equipment according to European Standard EN 55022 and EN 55024. In a domestic environment, this product may cause radio interference in which cause the user may be required to take adequate measures. www.acti.com...
-
Page 5: Safety Instructions
Safety Check Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine if the product is in proper operating condition. www.acti.com... -
Page 6: Introduction
Hardware Manual Introduction The List of Models This hardware manual contains the following models: Q970 2MP, Intercom, Basic WDR, Superior Low Light Sensitivity www.acti.com... -
Page 7: Package Contents
Hardware Manual Package Contents Check if the camera package comes with the following items. Camera Screws and Plugs Drill Template Drill Template Quick Installation Guide & 10-Pin Terminal Block 6-Pin Terminal Block Warranty Card Warranty Card www.acti.com... -
Page 8: Physical Description
Reset Button for at least 5 seconds or until the Power LED goes off. Digital Output Connects to digital output devices, such as an alarm trigger, etc. Cable Connections on page 11 for information. www.acti.com... -
Page 9: Installing The Camera
2. Connect the other end to a switch or injector. Then, connect the switch or injector to a network or PC and a power source. See Power-over-Ethernet (PoE) example connection diagram below. Network Ethernet Cable Ethernet Cable (Data) PoE Injector / Power Cable PoE Switch Ethernet Cable AC Power (Data + Power) Source Camera www.acti.com... -
Page 10: Step 4: Access The Camera Live View
3. As needed, connect and power up other devices, such as digital input/output, audio, or serial device. See Cable Connections on page 11 for more information on connecting other devices. Step 4: Access the Camera Live View Accessing the Camera on page 15 for more information. www.acti.com... -
Page 11: Cable Connections
Take note that a standard power adapter cable has two (2) different wires: Connects to GND Pin White stripe: Connects to 12V Pin NOTE: The power adapter is not bundled in the package. www.acti.com... -
Page 12: Connecting Di/Do Devices (Optional)
Isolation test voltage 3750 VRMS Typical RON 20 DC or peak AC load voltage 350 V Continuous DC load current (form C operation) 15 mA Output power dissipation (continuous) 600 mW Voltages accepted 350V AC/DC, 0.15A www.acti.com... -
Page 13: Connecting Serial Devices (Optional)
DATA+ pins labeled as “TX+”, “RX+”, "A” or “485+”, etc. Refer to the device documentation or contact the manufacturer to verify the corresponding pin labels and ensure proper wiring connection. CAUTION: Incorrect wiring may cause damage to the connected devices. DISCLAIMER: ACTi will not be responsible for any damage caused by improper wiring. www.acti.com... -
Page 14: Other Accessories
In case there is a need to remove the card, make sure to access the camera Web Configurator to safely “unmount” the card first (see the camera Firmware User’s Manual for more information). Once unmounted from the firmware, push the card to eject it from the slot. www.acti.com... -
Page 15: Accessing The Camera
In the example below, the camera that has just been connected to the network is successfully found. Double-click the mouse on the camera model name, the default browser of the PC is automatically launched and the IP address of the target camera is already filled in the address bar of the browser. www.acti.com... - Page 16 Search and downloand IP Utility for free from http://www.acti.com/DownloadCenter. When you launch IP Utility, the list of connected cameras in the network will be shown. See sample illustration below: You can quickly notice the camera model in the list.
- Page 17 PC has to be configured to match the network segment of the camera. Manually adjust the IP address of the PC In the following example, based on Windows 7, we will configure the IP address to 192.168.0.99 and set Subnet Mask to 255.255.255.0 by using the steps below: www.acti.com...
- Page 18 In such case, please plug in only one camera at a time, and change its IP address by using the Web browser before plugging in the next one. This way, the Web browser will not be confused about two devices having the same IP address at the same time. www.acti.com...
-
Page 19: Access The Camera
The examples in this manual are based on Internet Explorer browser in order to cover all functions of the camera. Assuming that the camera’s IP address is 192.168.0.100, you can access it by opening the Web browser and typing the following address into Web browser’s address bar: http://192.168.0.100 www.acti.com... - Page 20 Before logging in, you need to set up the root Account and Password of the camera. The password can contain upper and lower case letters and numbers. Then, use this newly set up Account and Password to login to the web configurator. For further operations, please refer to the Firmware User Manual. www.acti.com...
- Page 21 Copyright © 2022, ACTi Corporation All Rights Reserved 7F, No. 1, Alley 20, Lane 407, Sec. 2, Ti-Ding Blvd., Neihu District, Taipei, Taiwan 114, R.O.C. TEL : +886-2-2656-2588 FAX : +886-2-2656-2599 Email: sales@acti.com...