Roland GR-33 Owner's Manual page 70

Chapter 6 Using the Built-in Effects
32: EH CHO (Enhancer
This effect connects an enhancer and a chorus in series.
fig.6-35
L in
Enhancer
Mix
R in Enhancer
Mix
EH SENS (Enhancer sensitivity) 0–127
Specify the sensitivity of the enhancer.
EH MIX (Enhancer mix level) 0–127
Specify the volume of the overtones generated by the
enhancer, relative to the original sound.
CHO PRE DLY (Chorus pre delay time)
0.0–100 ms
Specify the time delay from the original sound until the
chorus sound is heard.
CHO RATE (Chorus rate) 0.05–10.0 Hz #
Specify the modulation frequency of the chorus sound.
CHO DEPTH (Chorus depth) 0–127
Specify the modulation depth of the chorus sound.
CHO BALANCE (Chorus balance)
D100:0E–D0:100E
Specify the volume balance between the enhancer sound that
does not pass through the chorus and the enhancer sound
that does pass through the chorus.
A setting of D100:0E will output only the enhancer sound,
and a setting of D0:100E will output only the enhancer sound
that is passed through the chorus.
LEVEL (Output level) 0–127
Specify the output volume.
70
Chorus)
L out
Balance D
Balance E
Chorus
Balance E
R out
Balance D
33: EH FL (Enhancer
This effect connects an enhancer and a flanger in series.
fig.6-36
L in
Enhancer
Mix
R in Enhancer
Mix
EH SENS (Enhancer sensitivity) 0–127
Specify the sensitivity of the enhancer.
EH MIX (Enhancer mix level) 0–127
Specify the volume of the overtones generated by the
enhancer, relative to the original sound.
FL PRE DLY (Flanger pre delay time)
0.0–100 ms
Specify the time delay from the original sound until the
flanger sound is heard.
FL RATE (Flanger rate) 0.05–10.0 Hz #
Specify the modulation frequency of the flanger sound.
FL DEPTH (Flanger depth) 0–127
Specify the modulation depth of the flanger sound.
FL FEEDBACK (Flanger feedback level) -98–+98 %
Specify the proportion (%) of the flanger sound which will be
returned to the input.
Positive (+) settings will return the sound to the input with
the original phase, while negative (-) settings produce an
inverted phase.
You can set a value from -98% to +98%, in steps of 2%. There
is no feedback when the value is zero.
FL BALANCE (Flanger balance)
D100:0E–D0:100E
Specify the volume balance between the enhancer sound that
does not pass through the flanger and the enhancer sound
that does pass through the flanger.
A setting of D100:0E will output only the enhancer sound,
and a setting of D0:100E will output only the enhancer sound
that is passed through the flanger.
LEVEL (Output level) 0–127
Specify the output volume.
Flanger)
Balance D
L out
Feedback
Balance E
Flanger
Balance E
R out
Balance D