Commands - GE 750 UL S2 User Manual

6.5 COMMANDS

The COMMANDS mode is entered any time the "CMDS" button is pressed.
Allows the user to execute UPS operation commands.
In this mode the buttons perform the following functions:
Return to HOME screen.
Scrolls forward to the next screen.
Scrolls forward to the next line.
Confirm the selection made.
It is possible to view any pushbutton functional description by pushing the button for more than 3
seconds.
Home\Commands
COMMANDS
LAMP TEST
INVERTER ON
INVERTER OFF
RECTIFIER ON
NOTE !
When eBoost™ Operation Mode is enabled, control of Inverter status and selection
of the feed path is done autonomously by the UPS control logic.
Therefore, Inverter ON / Inverter OFF commands are disabled when eBoost™
Operation Mode is enabled.
Home\ Commands
COMMANDS
RESET TOTAL OFF
REQUEST TOTAL OFF
Screen sequence to execute the command "
Home\Commands
COMMANDS
RESET TOTAL OFF
REQUEST TOTAL OFF
Modifications reserved
OPM_SGS_USM_M75_M75_2US_V010.doc
Commands screen 1
LAMP TEST
Signaling LEDs test and buzzer test (all LED should be lit and
blinking and the acoustical alarm should be activated).
INVERTER ON
INVERTER OFF
RECTIFIER ON
Commands screen 2
RESET TOTAL OFF
Reset Total OFF command should be executed to switch ON
UPS after a "Load Off" operation.
REQUEST TOTAL OFF
Command "Load Off".
Off":
Load
Home\Commands
COMMANDS
RESET TOTAL OFF
CANCEL TOTAL OFF
EXECUTE TOTAL OFF
Command to switch the inverter.
Command to shutdown the inverter.
Command to switch the rectifier.
Only for Service Center, the command
access is protected by a code.
As the command procedure
of "Load Off" is finished the
"REQUEST
screen appears again.
User Manual SG Series 750 UL S2 & SG Series 750 T12 UL S2
TOTAL OFF"
Page 43/71