Using The Hold (Overdubbing) Function; Begin Recording; Overdubbing; Adjust The Volume - Boss Digital Delay DD-6 Owner's Manual

Using the HOLD (Overdubbing) Function

With the HOLD function, you can record up to
5.2 seconds of your performance, and then
have that content played back repeatedly. You
can also layer this as you perform something
else, then record these together (overdub).
You can keep the recorded content playing
continuously as backing and produce other
special effects.
1. Select HOLD
Set the MODE switch to HOLD
CHECK indicator goes out)

2. Begin recording

Recording starts when you press the ped-
al switch. Hold down the pedal switch for
the duration of the recording
.
indicator flashes)
3. When recording is finished, playback starts
Release the pedal switch to stop record-
ing. Playback of the recorded content be-
14
(the
.
(the CHECK
gins simultaneously
.
remains lit)
* The maximum recording time is 5.2 seconds. If
the pedal switch is held down for more than 5.2
seconds, the recording stops automatically, and
the recorded content is then played back.
* An oscillating sound may be audible with
extremely short recording times.

4. Overdubbing

When layering recordings, repeat Steps 2 and 3.

5. Adjust the volume

Adjust the volume of the playback sound
with the E.LEVEL knob.
6. Finish playback
Press the pedal switch to stop the play-
back
(the CHECK indicator goes out)
* When playback is stopped, the recorded content is erased.
* The recorded content is erased when the mode is
switched, or when the power is turned off.
(the CHECK indicator
.