BABYTREND Rocket Stroller SE ST21 Instruction Manual page 4

ASSEMBLY
• Push the Center Pedal down completely to
lock the stroller open (Fig. 1c).
• To attach the front wheels, lean the stroller
back so that it rests on the handle with the
front legs pointing upward (Fig. 1d).
• Position the front wheels over the front leg
tubes so that the hole in the housing lines
up and will slide into the legs (Fig. 1e).
Firmly push down until the wheels lock
securely into place.
NOTE: Pull on each wheel to ensure they
are both securely attached.
2) • To remove the front wheel, push the tabs
and pull on the front wheel (Fig. 2).
5
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 1c
Center Pedal
Fig. 1d
Point Upward
Fig. 1e
Fig. 2
REAR WHEELS
3) • To attach the rear wheels, lean the stroller
forward so that the rear legs are pointing
upward (Fig. 3a).
• Position the rear wheels over the rear leg
tubes so that the hole in the housing lines
up and will slide into the legs (Fig. 3b).
Firmly push down until the wheels lock
securely into place.
NOTE: Pull on each wheel to ensure they
are both securely attached.
4) • To remove the rear wheel, push the tab
and pull off the rear wheel (Fig. 4).
NEVER use the stroller if wheels do not lock
into place. If you need assistance, please
contact Baby Trend Customer Service.
®
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 3a
Fig. 3b
Fig. 4
6