Table of Contents
Advertisement
If the rack has round and threaded holes, secure the rails using the supplied long screws
only (there is no need to use the snap-in spring-loaded cage nuts and the E-shaped
devices).
7. Secure the rails to the rack by inserting screws in the top and bottom holes on the left and
right sides on the front of the rack (as shown in the following figure). Do not insert screws into
the second-from-the-bottom hole at this time.
8. Insert screws into the middle two rear rail holes.
9. Verify that the rails are installed securely in the rack.
10. Carefully slide the array onto the rails, pushing it back until the flanges on the front of the
chassis meet the vertical supports.
DSN-5000 series Hardware Reference Guide
Figure B-3. Securing the Rails to the Rack
Figure B-4. Sliding the Array onto the Rails
39
Advertisement
Table of Contents
