Texecom Ricochet Impaq Contact-W - Security System Manual

INTRODUCTION

• For wireless connectivity, detailed programming and system set-up instructions please refer to the compatible RICOCHET™ technology enabled Premier Elite wireless expander instructions.
• Featuring RICOCHET™ wireless technology the Impaq Contact-W is designed for professional security installations.
• When using the Impaq Contact-W on an Entry/Exit route, or a 24HR door, or where chime is required, the device attributes should be left at default "Always Awake".
• Please see the Premier Elite 8XP-W/32XP-W Installation Manual for details of how to change the device attributes.

ASSEMBLY

For rear tamper - fix both the detector AND the rear tamper insert to the mounting surface. Activation of rear tamper will damage product.

BATTERY

Battery Safety

• Do not throw into a fire
• Do not heat
• Do not charge
• Do not short circuit
• Do not disassemble
• Replace only with same or equivalent type
• Always observe local regulations when disposing of a battery
• Detector will transmit low battery warning when battery needs replacing

Magnet
Non-Ferrous Mounting Material

• Maximum Break = 30mm
• Minimum Make = 15mm

Ferrous Mounting Material

• Maximum Break = 15mm
• Minimum Make = 5mm
  Note: Values depend on mounting material. See Fig.1
  

Reed Disable

	Disabled
	Enabled

Relearn
Place jumper on Relearn pin header and insert battery to learn device.

ADDITIONAL INPUTS 1 & 2

The Impaq Contact-W has 2 additional inputs. These may be used for any N/C device and utilise wireless signal transmission to the receiver. Typical examples for use are:-

• Any locally powered device with a N/C output e.g. Smoke detectors, Glass Break detectors, Movement Sensors, Flood detectors etc.
• Any non-powered N/C device, e.g. Additional magnetic contacts, fixed PA buttons etc.
• The in-built reed switch can be disabled.
• Configuration and programming options are detailed in the Premier wireless expander installation manual.
• Certain features and functions are control panel software dependent.

MAGNET POSITIONING

LED STATUS INDICATION

Only available in walktest mode
(See Premier wireless expander instructions)

Min Approach - Magnets must be mounted within this distance of the contact, to ensure closure.

Min Removal - Minimum distance at which the contact may open. - This should be considered as the maximum distance that the door / window can move when it is secured.

Max Removal - Maximum distance at which the contact will open.

STANDARDS

*Certified by Telefication BV
** Not INCERT approved.