Reef Factory RFLK01 User Manual page 3

I. Initial setup
Prepare the liquid level sensor
Connect the hook (part no. 4) to the probe holder (part no. 5) with the fixing screws and nuts
(key 2 and number 3).
Then insert the sensor with the cable (part 6) and the holder (part 5) as shown in the picture.
To do this, unscrew the top nut enough to insert the sensor into the holder (part 5), insert
the sensor, and then re-tighten the nut.
Hang the entire sensor on the aquarium wall and gently tighten the stabilizing screw (No. 1)
ATTENTION! Be careful not to twist the parts too tightly so as not to damage them.
Mount the level sensors in the tank
The level sensors should be mounted in the tank in such a way that they
correctly indicate the liquid level. Depending on the height of the water
in the aquarium, they can be mounted in two ways.
If you have a low water level in your tank, you can install a level sensor as
shown in the picture on the left.
However, if your tank has a high water level, you can mount the sensor
as shown in the picture on the right.
Reef Factory 2022
User manual Level keeper ©
3