Table of Contents
Advertisement
Available languages
Available languages
4. Lift the filter
13
out of the dust bowl
5. While holding the dust bowl over a trash can, empty the
dust bowl
5
.
6. Install the filter
13
into the dust bowl
the prefilter
12
into the dust bowl
7. Close the dust bowl access door
into place.
WARNING:
without the filters. Optimum dust collection will only
be achieved with a clean filter.
Fig. E
11
Fig. F
13
5
Cleaning the dust bowl and filter
1. The prefilter
12
and filter
soapy water. The dust bowl
a dry cloth.
2. Make sure the filter
13
dust bowl
5
are dry before installing.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
•
Remove the old filters as described in Emptying and
Cleaning the Product.
Fit the new filters as described in Emptying and
•
Cleaning the Product.
(cat. no: HHVKF10)
These fit all units. When these filters reach the end of their
lifespan they must be disposed of at a local recycling center.
5
.
5
, then install
5
.
11
until it clicks firmly
Never use the appliance
6
12
13
can be washed in warm
5
can be wiped clean with
, prefilter
12
and the
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never
let any liquid get inside the vac; never immerse any part of
the vac into a liquid.
WARNING:
completely dry before using it.
iMPORTAnT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service organizations,
always using identical replacement parts.
TROUBLESHOOTING
If the product does not work, check the following:
•
The charger was correctly plugged in for recharge. (It
feels slightly warm to the touch.)
•
The charger cord is not damaged and is
correctly attached.
•
The charger is plugged into a working electrical outlet.
For assistance with your product, visit our website
www.blackanddecker.com for the location of the service
center nearest you or call the BLACK+DECKER help line at
1–800–544–6986.
Battery Removal and Disposal
This product uses Lithium Ion rechargeable and recyclable
batteries. When the batteries no longer hold a charge, they
should be removed from the vacuum and recycled. They
must not be incinerated or composted.
The batteries can be taken for disposal to a BLACK+DECKER
Company‑Owned or Authorized Service Center. Some local
retailers are also participating in a national recycling program
(see "RBRC® Seal"). Call your local retailer for details. If you
bring the batteries to a BLACK+DECKER Company‑Owned or
Authorized Service Center, the Center will arrange to recycle
old batteries. Or, contact your local municipality for proper
disposal instructions in your city/town.
To remove the battery pack for disposal:
1. First, before attempting to disassemble the product, turn
it on and leave it on until the motor completely stops
insuring a complete discharge of the batteries.
2. Using a hex screwdriver, remove the seven screws
securing the two housing halves.
3. Lift the housing cover away from the assembly.
4. Detach all lead connections from battery pack.
5. Remove battery pack and dispose of as per
recommended guidelines.
Accessories
WARNING:
than those offered by BLACK+DECKER, have not been
tested with this product, use of such accessories with
this product could be hazardous. To reduce the risk of
injury, only BLACK+DECKER recommended accessories
should be used with this product.
English
Make sure the vacuum is
Since accessories, other
7
Advertisement
Table of Contents
