Table of Contents
Advertisement
Available languages
Available languages
English
WARNING:
empty all contents and dry thoroughly if needed to
avoid damage to your appliance.
1. Before first use, the battery must be charged for at least
5 hours.
2. Make sure the appliance is switched off.
3. Fig. B ‑ Plug the jack plug
into the charging port
4. Plug the charger into any standard 120 Volt 60 Hz
electrical outlet.
Fig. B
nOTE: While charging, the charger may become warm. This
is normal and does not indicate a problem. The appliance
can be left connected to the charger indefinitely.
WARNING:
at ambient temperatures below 39 °F (4 °C) or above
104 °F (40 °C).
Charging Indicator LED
1. While charging, the white LEDs on the charger
flash and increase in sections.
2. When charging is completed, the white LEDs will turn
off.
Switching On/Off (Fig. C)
1. To switch the appliance ON, press the On/Off switch
2. Press the On/Off switch
3. Press the On/Off switch
Fig. C
1
6
Before charging, be sure to
9
of the jack plug charger
7
of the vacuum.
9
7
Do not charge the battery
1
again to engage boost mode.
1
to turn the vacuum Off.
State of charge indicator
This appliance includes a state of charge indicator
consists of three white LED lights
level of charge remaining in the battery. This feature is only
activated when the vacuum is powered on.
The state of charge indicator is an indication of approximate
levels of charge remaining in the battery pack according to
8
the following indicators:
The LED battery indicator displays the remaining charge
and warns you when the battery is low. The final LED will
flash continuously when there is only 1 minute of runtime
remaining. All LEDs will flash when the unit is discharged.
nOTE: The state of charge indicator is only an indication
of the charge left on the battery. It does not indicate tool
8
functionality and is subject to variation based on product
components, temperature and end‑user application.
Fig. D
Extendable Crevice Tool
1. To extend the crevice tool
vacuum nozzle
2. To collapse the crevice tool
nozzle
3
8
will
Dry pick up
For everyday spills of dry material.
-
Do not fill the dust bowl
filter.
Optimizing the suction force
1
.
In order to keep the suction force optimized, the filters must
be cleared regularly during use.
Emptying and cleaning the product
Removing the dust bowl and filter (Fig. E, F)
WARNING:
should be cleaned regularly.
1. Hold the dust bowl over a trash can before pressing the
dust bowl release button
access door
2. While holding the dust bowl over a trash can, lightly
shake it to empty the dust bowl
3. Lift the prefilter
in Figure F.
10
that indicate the
10
4
, pull it out from the
3
until it clicks in place.
4
, push it into the vacuum
until it clicks in place.
5
beyond the end of the
The filter is reusable and
6
to release the dust bowl
11
as shown in Figure E.
5
12
out of the dust bowl
2
which
2
.
5
as shown
Advertisement
Table of Contents
